DMM DYN4 Servo Spindle Retrofit

Replacing Brushless DC Motor with Servo Motor

Working on replacing the original spindle motor on my DynaMyte 2800 with a DMM DYN4 Servo System. Going to try a 750 Watt AC Servo Motor- the 86M-DHT from Dynamic Motor Motion. In this video I prepare the mill for installation of the new motor and rearrange the electrical panel for the DYN4 AC Servo Drive.

I also take advantage of the space savings created by the new drive to install the Centroid Ether1616 I/O Expansion kit, as well as an upgraded 24volt power supply and Ethernet switch.

Leave a comment

Your email address will not be published. Required fields are marked *